Menu Close

STorM32 NT IMU Module v3.0


Out of stock


  • IMU Input voltage: 2 – 5.5 V.
  • Compatible with StorM32 version: 2.03-NT and higher.
  • Board dimensions: 11.7mm x 17.5mm x 2mm.
  • Sensor: TDK-Invensense MPU-6050

LED Status:

  • 1Hz blink – OK, camera IMU setting.
  • double-blink – OK, 2nd IMU setting.
  • triple-blink – OK, 3rd IMU setting.
  • 5Hz fast blinking – Error status. The controller is
    unable communicate with MPU6050 chip.

3rd/2nd/Camera IMU setting:
The module works as a camera IMU by default,
to set it as a 2nd IMU, the „2nd IMU“ solder bridge
should be shorted. To set it as a 3rd IMU, the „3rd IMU“ solder bridge
should be shorted.

– A tested and working StorM32 NT V3.0 IMU Module with latest firmware.

Accelerometer Calibration

Uncalibrated, 6-point Embedded Factory Calibration


1.25mm socket (Straight), 1.25mm socket (Right Angle), None (Bare solder pads)

Include Pigtail Wire (15cm)

Yes, No


There are no reviews yet.

Be the first to review “STorM32 NT IMU Module v3.0”