Version 2.0 NT IMU modules for STorM32 are ready walmis June 22, 2016 SToRM32 2 Comments Hello World! Version 2.0 IMU modules which are more compact are now available! Head to our shop to check them out. Post navigation Previous Previous post: First batch of v2.0 NT IMU ModulesNext Next post: Firmware update for “Cannot calibrate IMU” problem 2 Comments Gordon July 12, 2016 at 10:10 Reply Hi, Just received 2 imu modules and noticed there is a fine track very close to the solder pads with no solder mask. The track is ground and it would be very easy to create a bridge when soldering which would short out the nt bus. I think the pcb files need a slight adjustment on both sides of the board. The modules work just fine as long as you solder carefully. walmis Post author July 12, 2016 at 10:29 Reply Hi, thanks for your feedback! This problem will be fixed for any new ordered modules. Leave a Reply to walmis Cancel replyYour email address will not be published. Required fields are marked *Comment Name * Email * Website Save my name, email, and website in this browser for the next time I comment.