Posted on

New NT Motor drivers soon!

I’ve been working on new NT motor board design. I’ve reduced the size, made it more streamlined and added a regulator which will allow the board to work directly from 12V input. I also included a selectable voltage output by using a solder jumper, which will allow to pass the power to the next motor module or to pass 3.3V to the IMU module. This will save wires running through the gimbal.

I will fix some minor bugs and will run the board to production and will make preorders available in the shop.

Board dimensions 25mm x 27mm

Leave a Reply

Your email address will not be published. Required fields are marked *